Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2018 >> CX-5 Touring, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> On-Board Diagnostics - Automatic Transaxle >> DTC P0218-00: Automatic Transaxle Protection Control >> Diagnostic Procedure

Diagnostic Procedure

DTC P0218:00 TCM (FW6A-EL, FW6AX-EL) DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 RECORD VEHICLE STATUS WHEN DTC WAS DETECTED TO UTILIZE WITH REPEATABILITY VERIFICATION
NOTE:
  • Recording can be facilitated using the screen capture of the PC function
  • Record the freeze frame data/snap shot data.
 - Go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY
  • Verify related Service Bulletins and/or on-line repair information availability
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT ATF LEVEL Yes Adjust the ATF level to the specification, then go to Step 5.
(See Automatic Transaxle Fluid (ATF) Adjustment .)
No Go to the next step.
4 INSPECT OIL COOLER
  • Visually inspect the oil cooler
  • Is there any malfunction?
 Yes Replace the oil cooler, then go to the next step.
(See Oil Cooler Removal/Installation .)
No Go to the next step.
5 VERIFY DTC TROUBLESHOOTING COMPLETED Yes Go to the applicable DTC inspection.
(See On-board Diagnostic System DTC Table .)
No DTC troubleshooting completed.
scientia non olet · About Mike's Workshop Manuals