Diagnostic Procedure

DTC C0061:54/C0062:54/C0063:54 (DYNAMIC STABILITY CONTROL) DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY INITIALIZATION PROCEDURE Was the DSC related parts sensor initialization procedure performed?	Yes	Go to the next step.
1		No	Perform the DSC related parts sensor initialization procedure, then go to Step 3. (See DSC RELATED PARTS SENSOR INITIALIZATION PROCEDURE .)
2	INSPECT SAS CONTROL MODULE MALFUNCTION Switch the ignition to off. Using the M-MDS, perform the DTC inspection for the SAS control module. (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC. )].) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC. )].)
2		No	Go to the next step.
3	VERIFY THAT THE SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (See CLEARING DTC (Dynamic Stability Control (DSC)) .) Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the DSC HU/Control Module, then go to the next step. (See DSC HU/Control Module REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (WITH CYLINDER DEACTIVATION)] .)
3		No	Go to the next step.
4	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See DTC TABLE (Dynamic Stability Control (DSC)) .)
4		No	DTC troubleshooting completed.