360°View Monitor Control Module Removal/Installation

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the following parts.
(1)Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .) (2)Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION .) (3)Passenger-side side wall (See SIDE WALL REMOVAL/INSTALLATION .)
Partially peel back the floor covering.
Remove the foot support. (See FOOT SUPPORT REMOVAL/INSTALLATION .)
Remove the nuts.

Fig 1: Removing 360° View Monitor Control Module Nuts
Courtesy of MAZDA MOTORS CORP.
Remove the cover.
Disconnect the connector.

Fig 2: Disconnecting 360° View Monitor Control Module Component Connector
Courtesy of MAZDA MOTORS CORP.
Remove the wiring harness clips.
Remove the nuts.
Remove the 360° view monitor control module component.
Remove the screws.

Fig 3: Removing 360° View Monitor Control Module Component Screws
Courtesy of MAZDA MOTORS CORP.
Remove the 360° view monitor control module from the bracket.
Install in the reverse order of removal.
Perform the 360° view monitor system aiming. (See 360°VIEW MONITOR SYSTEM AIMING .)