Diagnostic procedure

WARNING: This page is about a different variant/trim than selected.

DTC U2100-00; AWD CONTROL MODULE CONFIGURATION - DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	ALLOW VEHICLE TO COOL DOWN SWITCH THE IGNITION TO OFF AND ALLOW the vehicle TO COOL DOWN.		Go to the next step.
2	VERIFY DTC TROUBLESHOOTING COMPLETED Using the M-MDS, clear the DTC from the AWD control module. (See CLEARING DTC [AWD CONTROL MODULE] .) Using the M-MDS, perform the AWD control module DTC inspection. (See DTC INSPECTION [AWD CONTROL MODULE] .) Is the same DTC present?	Yes	Replace the AWD control module. (See AWD CONTROL MODULE REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [AWD CONTROL MODULE] .)
3	VERIFY NO DTC IS PRESENT Are any DTCs present?	No	DTC troubleshooting completed.