Diagnostic Procedure

WARNING: This page is about a different car, the 2018 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.

DTC U3000:95 (360°VIEW Monitor Control Module) DIAGNOSTIC PROCEDURE

Step	Inspection		Action
1	VERIFY IF 360°VIEW MONITOR CONTROL MODULE WAS INSTALLED ON DIFFERENT VEHICLE Verify if the 360°view monitor control module was installed on a different vehicle. Was the 360°view monitor control module installed on a different vehicle?	Yes	Go to the next step.
1		No	Go to Step 3.
2	READ VEHICLE INFORMATION SENT FROM INSTRUMENT CLUSTER TO 360°VIEW MONITOR CONTROL MODULE After switching the ignition off, switch the ignition ON (engine off or on) again. Clear the DTC for the 360°view monitor control module using the MMDS. (See CLEARING DTC (360°VIEW Monitor Control Module) .) Switch the ignition ON (engine off or on) and wait for 1.5 s or more. Retrieve the 360°view monitor control module DTCs using the M-MDS. (See DTC INSPECTION (360°VIEW Monitor Control Module) .) Is the same Pending DTC present?	Yes	Go to the next step.
2		No	Go to Step 6.
3	VERIFY INSTRUMENT CLUSTER DTCs Retrieve the instrument cluster DTCs using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER] .) Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER] .)
3		No	Go to the next step.
4	VERIFY IF MALFUNCTIONING LOCATION IS INSTRUMENT CLUSTER DEPENDING ON REPEATABILITY Clear the DTC for the 360°view monitor control module using the MMDS. (See CLEARING DTC (360°VIEW Monitor Control Module) .) Switch the ignition ON (engine off or on) and wait for 1.5 s or more. Retrieve the 360°view monitor control module DTCs using the M-MDS. (See DTC INSPECTION (360°VIEW Monitor Control Module) .) Is the same Pending DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION .)
4		No	Go to Step 6.
5	VERIFY THAT REPAIRS HAVE BEEN COMPLETED Clear the DTC for the 360°view monitor control module using the MMDS. (See CLEARING DTC (360°VIEW Monitor Control Module) .) Retrieve the 360°view monitor control module DTCs using the M-MDS. (See DTC INSPECTION (360°VIEW Monitor Control Module) .) Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the 360°view monitor control module. (See 360°VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION .) Go to the next step.
5		No	Go to the next step.
6	VERIFY IF OTHER DTCs DISPLAYED Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE (360°VIEW Monitor Control Module) .)
6		No	DTC troubleshooting completed.