Resistance Inspection: Notes

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Disconnect the MAP sensor/IAT sensor No. 2 connector.
Remove the MAP sensor/IAT sensor No. 2. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR NO. 2 REMOVAL/INSTALLATION .)
Measure the resistance between MAP sensor/IAT sensor No. 2 terminals A and B.

Fig 1: MAF Sensor/IAT Sensor No 2 Connector Terminals
Courtesy of MAZDA MOTORS CORP.
- If not as specified, replace the MAP sensor/IAT sensor No. 2. (See MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR NO. 2 REMOVAL/INSTALLATION .)