Tie Rod Assembly Note

Install the SST to the torque wrench as shown in the figure, set it on the tie rod, and measure dimensions A and L shown in the figure.

Fig 1: Installing SST To Torque Wrench
Courtesy of MAZDA MOTORS CORP.
Tighten the tie rod after calculating the tightening torque using the following formula.

Fig 2: Tightening Tie Rod
Courtesy of MAZDA MOTORS CORP.

Tightening torque

69-98 N.m {7.1-9.9 kgf.m, 51-72 ft.lbf}

Calculation formula

Tx(L/A)

T:Tightening torque (69-98 N.m {7.1-9.9 kgf.m, 51-72 ft.lbf})

L:Torque wrench effective length

A:Length from center of tie rod to grip