Foreword [SAS Control Module (Two-Step Deployment Control System)]: Identification
- In this information, "Two-step deployment control system" or "Standard deployment control system" is used if the service contents differ depending on the control.
- Control is identified by the following components.
x: Equipped-: Not equipped
| Item | Two-step deployment control system | Standard deployment control system |
|---|---|---|
| Sophisticated air bag sensor (SAS) control module | x | x |
| Crash zone sensor | x | x |
| Side air bag sensor | x | - |
| Pressure sensor | x | - |
| Driver-side air bag module | x (Two-step deployment type) | x (Standard deployment type) |
| Passenger-side air bag module | x (Two-step deployment type) | x (Standard deployment type) |
| Side air bag module | x | - |
| Curtain air bag module | x | - |
| Lap pre-tensioner seat belt | x | - |
| Pre-tensioner seat belt | x | x |
| Clock spring | x (Two-step deployment type) | x (Standard deployment type) |
| Occupant classification sensor | x | - |
| Occupancy sensor | - | x |
| Driver-side buckle switch | x | x |
| Passenger-side buckle switch | x | x |
| Air bag system warning light | x | x |
Outline
- The OBD (on-board diagnostic) system has the following functions:
- Malfunction detection function: Detects malfunctions in the air bag system and outputs DTCs (Diagnostic Trouble Codes).
- PID/data monitor function: Reads out specific input/output signals and the system status.
- DTCs can be read/cleared using the M-MDS.
NOTE:
- Use the M-MDS to verify DTCs because the DTCs displayed by the air bag system warning light are reference information only.