Diagnostic Procedure
DTC U3000-54; RADAR AIMING IS NOT PERFORMED OR RADAR SENSOR AXIS IS DEVIATED (BLIND SPOT MONITORING (BSM) CONTROL MODULE (LH) - DIAGNOSTIC PROCEDURE
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | PERFORM BLIND SPOT MONITORING (BSM) CONTROL MODULE (LH) RADAR AIMING
|
Yes | Perform the blind spot monitoring (BSM) control module (LH) radar aiming again, then go to the next step. (See BLIND SPOT MONITORING (BSM) RADAR AIMING .) |
| No | Go to Step 3. | ||
| 2 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the blind spot monitoring (BSM) control module (LH), then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [BLIND SPOT MONITORING (BSM) CONTROL MODULE] .) |
| No | DTC troubleshooting completed. | ||