DTC U1A4B-54; Radar Aiming Is Not Performed Or Radar Sensor Axis Is Deviated (Blind spot Monitoring (BSM) Control Module (RH): Notes

CAUTION:

When replacing a blind spot monitoring (BSM) control module (RH) having any of the following part numbers, it is necessary to replace the blind spot monitoring (BSM) control module (LH) at the same time to perform the configuration normally.

DB2R-67Y80
DB2R-67Y80 A

DTC U1A4B-54; RADAR AIMING IS NOT PERFORMED OR RADAR SENSOR AXIS IS DEVIATED (BLIND SPOT MONITORING (BSM) CONTROL MODULE (RH) - DETECTION CONDITION & POSSIBLE CAUSE

Description	Radar aiming is not performed or radar sensor axis is deviated (Blind spot monitoring (BSM) control module (RH))
Detection condition	Malfunction in radar aiming of the blind spot monitoring (BSM) control module (RH) detected for 1 s or more with the ignition switched ON (engine off or on).
Fail-safe	Blind spot monitoring (BSM) system is stopped.
Possible cause	Blind spot monitoring (BSM) radar aiming (RH) was not performed. Deviation of blind spot monitoring (BSM) control module (RH) radar sensor axis Blind spot monitoring (BSM) control module (RH) malfunction
System wiring diagram	Not applicable