Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2017 >> 5 GT, Automatic Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle (Service Information) >> Control Valve Body Removal/Installation >> Secondary Control Valve Body On-Vehicle Removal

Secondary Control Valve Body On-Vehicle Removal

WARNING:
  • Do not perform the servicing while the ATF is hot. Otherwise, it could cause severe burns or serious injury.
  • Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or soiling could spatter and get into the eyes.
CAUTION:
  • Do not allow foreign material or water to penetrate the connector. Otherwise, it could cause poor contact and corrosion.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  2. Disconnect the negative battery cable.
  3. Remove the battery. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  4. Remove the battery tray. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  5. Remove the aerodynamic under cover. (See AERODYNAMIC UNDER COVER REMOVAL/INSTALLATION .)
  6. Clean the outside of the transaxle using steam or detergent oil.
  7. Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT .)
  8. Disconnect the solenoid valve connector.
    G13727422Courtesy of MAZDA MOTORS CORP.
  9. Remove the bolts and GND shown in the figure and remove the secondary control valve body.
    G13727423Courtesy of MAZDA MOTORS CORP.
  10. Remove the tubular pin and O-rings.
    G13727424Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals