Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2017 >> 5 GS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle (Service Information)) >> Input/Turbine Speed Sensor Inspection >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the input/turbine speed sensor connector.
    1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
    2. Disconnect the negative battery cable.
    3. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 2.5] .)
    4. Disconnect the input/turbine speed sensor connector.
      G13727435Courtesy of MAZDA MOTORS CORP.
  2. Measure resistance between input/turbine speed sensor terminals A and B.
    G13727436Courtesy of MAZDA MOTORS CORP.

    Input/turbine speed sensor resistance 

    250-600 ohms

scientia non olet · About Mike's Workshop Manuals