Snap shot data table
NOTE:
- Refer to PID monitor table for confirm the transaxle control system operation status while the TCM does not store the DTC. (See ON-BOARD DIAGNOSTIC SYSTEM PID/DATA MONITOR INSPECTION .)
- Snap shot data items are not displayed, according to detected DTC.
SNAP SHOT DATA PART DESCRIPTION
| Snap shot data item | Unit | Data contents | Corresponding data monitor items |
|---|---|---|---|
| LOAD | % | Charging efficiency | - |
| ECT | °C {°F} | Engine coolant temperature | ECT |
| RPM | RPM | Engine speed | RPM |
| VSS | KPH {MPH} | Vehicle speed | VSS |
| SPARKADV | ° | Ignition advance | - |
| IAT | °C {°F} | Intake air temperature | - |
| TP1 | % | Throttle position sensor No. 1 | THOP |
| EG_RUN_TIME | hh:mm:ss | Time since engine start | - |
| CLR_CNT | - | Number of warm-ups after DTCs are erased | - |
| CLR_DIST | Km {MILE} | Traveled distance after DTCs are erased | - |
| VPWR | V | Power supply voltage | VPWR |
| APP1 | % | Accelerator pedal position No. 1 | - |
- Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. (See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE .)
- After completion of repairs, clear all DTCs stored in the TCM. (See CLEARING DTCS PROCEDURE .)