Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2016 >> MX-5 Miata Club, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transaxle System (Service Information)) >> TCM Removal/Installation

TCM Removal/Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not drop or apply a shock to the TCM. Replace the TCM if it has been dropped or received an impact.
  • Make sure that your hand does not touch the terminal as the connector terminal could be damaged.
  • Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Disconnect the connectors.
    Fig 1: Disconnecting Connectors
    G10952846Courtesy of MAZDA MOTORS CORP.
  3. Remove the TCM.
    Fig 2: Removing TCM
    G10952847Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
  5. Perform the "Initial Learning" (TCM replacement). (See INITIAL LEARNING PROCEDURE .)
scientia non olet · About Mike's Workshop Manuals