Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2016 >> MX-5 Miata Club, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transaxle Shift Mechanism) >> Automatic Transmission Shift Mechanism Removal/Installation >> Control Rod Removal/Installation >> Nut, Washer and Control Rod Component Removal Note

Nut, Washer and Control Rod Component Removal Note

WARNING: This page is about a different variant/trim than selected.
  1. Secure the control rod component with an adjustable wrench as shown in the figure.
    Fig 1: Securing Control Rod Component With Adjustable Wrench
    G10952980Courtesy of MAZDA MOTORS CORP.
    CAUTION:
    • Do not use an impact wrench.
    • When loosening the control rod nut, secure the control rod component without applying torque within the AT.
  2. Remove the control rod nut.
    Fig 2: Removing Control Rod Nut
    G10952981Courtesy of MAZDA MOTORS CORP.
  3. Remove the washer and control rod component.
scientia non olet · About Mike's Workshop Manuals