Diagnostic Procedure
| Step | Inspection | Action | |
|---|---|---|---|
| 1 | PERFORM BLIND SPOT MONITORING (BSM) CONTROL MODULE (RH) RADAR AIMING
|
Yes | Perform the blind spot monitoring (BSM) control module (RH) radar aiming again, then go to the next step. (See BLIND SPOT MONITORING (BSM) RADAR AIMING .) |
| No | Go to Step 3. | ||
| 2 | VERIFY THAT REPAIRS HAVE BEEN COMPLETED
|
Yes | Replace the blind spot monitoring (BSM) control module, then go to the next step. (See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION .) |
| No | Go to the next step. | ||
| 3 | VERIFY IF OTHER DTCs DISPLAYED
|
Yes | Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [BLIND SPOT MONITORING (BSM) CONTROL MODULE] .) |
| No | DTC troubleshooting completed. | ||