| DETECTION CONDITION |
- Variation in fuel pressure is less than 5 kPa {0.05 kgf/cm 2
, 0.7 psi}
with the following conditions met.
MONITORING CONDITIONS
- Battery voltage: 8 V or more
- Ignition switched ON (engine on)
- Engine speed: 500-2, 500 rpm
- Engine load: 0.5 %
- The following DTCs are not detected:
- Low fuel pressure sensor: P2541-00:, P2542-00:
Diagnostic support note
- This is a continuous monitor (CCM).
- The check engine light does not illuminate.
- FREEZE FRAME DATA is not available.
- Snapshot data is available.
- DTC is stored in the PCM memory.
|