Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2016 >> 6 Touring, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transaxle (Service Information)) >> Back-Up Light Switch Removal/Installation

Back-Up Light Switch Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Remove the air cleaner component (air cleaner, air hose). (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  3. Remove in the order indicated in the table.
    Fig 1: Removing Back-Up Light Switch
    G10986134Courtesy of MAZDA MOTORS CORP.
    COMPONENT DESCRIPTION

    1 Connector
    2 Back-up light switch
    3 Gasket
  4. Install in the order indicated in the table.
    Fig 2: Installing Back-Up Light Switch
    G10986135Courtesy of MAZDA MOTORS CORP.
    COMPONENT DESCRIPTION

    1 Gasket
    2 Back-up light switch
    3 Connector
  5. Install the air cleaner component (air cleaner, air hose). (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  6. Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
scientia non olet · About Mike's Workshop Manuals