Clearing DTCs Procedures
WARNING: This page is about a different variant/trim than selected.
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- Select "Self Test".
- Select "Modules".
- Select "TCM".
- Select "Retrieve CMDTCs".
- Verify the DTC according to the directions on the screen.
- Press the clear button on the DTC screen to clear the DTC.
- Switch the ignition off.
- Close all of the doors, hood, trunk lid, and liftgate, lock the doors, and wait for 3 min .
- Switch the ignition ON (engine off or on) and wait for 5 s or more.
- Perform DTC inspection. (Refer to READING DTCS PROCEDURE .)
- Verify that no DTCs are displayed.