| 1 |
VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA HAS BEEN RECORDED
- Has the FREEZE FRAME DATA (Mode 2)/snapshot data been recorded?
|
Yes |
Go to the next step. |
| No |
Record the FREEZE FRAME DATA (Mode 2)/snapshot data on the repair order, then go to the next step. |
| 2 |
VERIFY RELATED REPAIR INFORMATION AVAILABILITY
- Verify related Service Bulletins and/or on-line repair information availability.
- Is any related repair information available?
|
Yes |
Perform repair or diagnosis according to the available repair information.
- If the vehicle is not repaired, go to the next step.
|
| No |
Go to the next step. |
| 3 |
VERIFY STORED DTC IN DSC HU/CM
|
Yes |
Go to the applicable DTC inspection.
(Refer to ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)]
.) |
| No |
Go to the next step. |
| 4 |
VERIFY DTC TROUBLESHOOTING COMPLETED
- Always reconnect all disconnected connectors.
- Clear the DTC from the PCM memory using the M-MDS.
(Refer to AFTER REPAIR PROCEDURE [SKYACTIV-G 2.0, SKYACTIV-G 2.5]
.)
- Access the RPM and LOAD PIDs using the M-MDS.
(Refer to ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5]
.)
CAUTION:
- While performing this step, always operate the vehicle in a safe and lawful manner.
- When the M-MDS is used to observe monitor system status while driving, be sure to have another technician with you, or record the data in the M-MDS using the PID/DATA MONITOR AND RECORD capturing function and inspect later.
- Drive the vehicle under the following conditions for 14 s
.
- Absolute load: above 40 %
- Engine speed: above 2, 000 rpm
- Perform the Pending Trouble Code Access Procedure.
(Refer to ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.0, SKYACTIV-G 2.5]
.)
- Is the PENDING CODE for this DTC present?
|
Yes |
Replace the PCM, then go to the next step.
(Refer to PCM REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5]
.) |
| No |
Go to the next step. |
| 5 |
VERIFY AFTER REPAIR PROCEDURE
|
Yes |
Go to the applicable DTC inspection.
(Refer to DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5]
.) |
| No |
DTC troubleshooting completed. |