Diagnostic procedure

STEP	INSPECTION		ACTION
1	INSPECT FOR SAS CONTROL MODULE MALFUNCTION Switch the ignition to off. Using the M-MDS, perform the DTC inspection for the SAS control module. (Refer to DTC INSPECTION [STANDARD DEPLOYMENT CONTROL SYSTEM] .) (Refer to DTC INSPECTION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (Refer to DTC TABLE [STANDARD DEPLOYMENT CONTROL SYSTEM] .) (Refer to DTC TABLE [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)
1		No	Go to the next step.
2	VERIFY THAT THE SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (Refer to ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the SAS control module, then go to the next step. (Refer to SAS CONTROL MODULE REMOVAL/INSTALLATION [STANDARD DEPLOYMENT CONTROL SYSTEM] .) (Refer to SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (Refer to ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
3		No	DTC troubleshooting completed.