Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2014 >> 6 Touring, 2.5L Eng VIN 6, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control System >> DSC HU/Cm Removal/Installation >> Brake Pipe Removal Note

Brake Pipe Removal Note

  1. Place an alignment mark on the brake pipe and DSC HU/CM.
  2. Apply protective tape to the connector to prevent brake fluid from entering.
  3. Disconnect the brake pipes.
    Fig 1: Identifying Brake Pipe And DSC HU/CM Alignment Mark
    G09785866Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals