Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2014 >> 3 SV, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic - Engine Controls (3 Of 6) >> DTC P0520 00: Oil Pressure Switch Circuit Problem >> Diagnostic Procedure

Diagnostic Procedure

DTC P0520:00 (SKYACTIV-G 2.0, SKYACTIV-G 2.5) - DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
2 INSPECT OIL PRESSURE SWITCH CONNECTOR CONDITION 
  • Switch the ignition off.
  • Disconnect the oil pressure switch connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the connector and/or terminals, then go to Step 6.
No Go to the next step.
3 INSPECT PCM CONNECTOR CONDITION 
  • Disconnect the PCM connector.
  • Inspect for poor connection (such as damaged/pulled-out pins, corrosion).
  • Is there any malfunction?
 Yes Repair or replace the connector and/or terminals, then go to Step 6.
No Go to the next step.
4 INSPECT OIL PRESSURE SWITCH SIGNAL CIRCUIT FOR OPEN CIRCUIT 
  • Verify that the oil pressure switch and PCM connectors are disconnected.
  • Inspect for continuity between oil pressure switch terminal A (wiring harness-side) and PCM terminal "IP (wiring harness-side).
  • Is there continuity?
 Yes Go to the next step.
No Refer to the wiring diagram and verify whether or not there is a common connector between oil pressure switch terminal A and PCM terminal 1 P.
If there is a common connector: 
  • Determine the malfunctioning part by inspecting the common connector and the terminal for corrosion, damage, or pin disconnection, and the common wiring harness for an open circuit.
  • Repair or replace the malfunctioning part.

If there is no common connector: 
  • Repair or replace the wiring harness which has an open circuit.

Go to Step 6.
5 INSPECT OIL PRESSURE SWITCH 
  • Inspect for continuity between oil pressure switch terminal A (part-side) and body ground.
  • Is there continuity?
 Yes Go to the next step.
No Replace the oil pressure switch, then go to the next step.
(See ENGINE OIL SOLENOID VALVE REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
6 VERIFY DTC TROUBLESHOOTING COMPLETED 
 Yes Repeat the inspection from Step 1.

Go to the next step.
No Go to the next step.
7 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
No DTC troubleshooting completed.
scientia non olet · About Mike's Workshop Manuals