Pre-Delivery Inspection Table
WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Cigarette lighter and clock
- Power windows
- Heater, defroster, and air conditioner at various mode selections (if equipped)
INSPECT the following items:
- Presence of spare fuse
- Upholstery and interior finish
INSPECT and ADJUST , if necessary, the following items:
- Operation and fit of windows
- Pedal height and free play of brake and clutch pedals
- Parking brake
Under hood-engine running at operating temperature
INSPECT the following items:
- Automatic transmission/Transaxle fluid level
- Operation of idle-up system for electrical load, air conditioner or power steering (if equipped)
- Operation of throttle position sensor (when inspecting for wiring harness and connector poor connection)
On hoist
INSPECT the following items:
- Manual transmission/Transaxle oil level
- Underside fuel, coolant and hydraulic lines, fittings, connections, and components for leaks
- Tires for cuts or bruises
- Steering linkage, suspension, exhaust system, and all underside hardware for looseness or damage
- Differential oil level
Road test
INSPECT the following items:
- Brake operation
- Clutch operation
- Steering control
- Engine general performance
- Emergency locking retractors and automatic locking retractors
- Cruise control system (if equipped)
- Operation of meters and gauges, squeaks, rattles, and abnormal noises
After road test
INSPECT for necessary owner information materials, tools, and spare tire in vehicle
The following items must be completed just before delivery to your customer.
- Load test battery and charge if necessary (Load test result: Volts)
- Adjust tire pressures to specification
- Adjust the tire pressures when the tire are cool.
- Specified pressure is indicated on the door label.
Tire pressure record Left front Right front Left rear Right rear Spare - After adjusting the tire pressures, switch the ignition ON (engine off or on) and long-press the tire pressure monitoring system set switch until the tire pressure warning light flashes two times and the buzzer sounds one tin (with tire pressure monitoring system switch).
Indicated that long-pressing of the tire pressure monitoring system set switch was implemented Yes or No - Clean outside of vehicle
- Remove seat and cabin carpet protective covers
- Vacuum inside of vehicle