Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2014 >> 3 SV, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Control System) >> Engine Coolant Temperature (ECT) Sensor Inspection >> ECT Sensor No. 2 >> Resistance inspection

Resistance inspection

WARNING: This page is about a different car, the 2014 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
  2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT .)
  3. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
  4. Disconnect the ECT sensor No. 2 connector. (See ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION .)
  5. Remove the ECT sensor No. 2. (See ENGINE COOLANT TEMPERATURE (ECT) SENSOR REMOVAL/INSTALLATION .)
  6. Place the ECT sensor No. 2 in water with a thermometer, and heat the water gradually.
    Fig 1: Checking ECT Sensor No. 2 Resistance
    G09785525Courtesy of MAZDA MOTORS CORP.
  7. Measure the resistance between ECT sensor No. 2 terminals A and B.
    ECT SENSOR NO. 2 SPECIFICATION

    ECT (°C {°F}) Resistance (Kilohms)
    20 {68} Approx. 2.45
    80 {176} Approx. 0.318
    Fig 2: ECT Sensor No. 2 Resistance Graph
    G09785524Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals