Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2014 >> 3 SV, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic - Engine Controls (1 Of 6) >> DTC P0088 00: Fuel Pressure Sensor Circuit Range/Performance Problem >> Troubleshooting Diagnostic Procedure

Troubleshooting Diagnostic Procedure

Intention of troubleshooting procedure 

STEP INSPECTION RESULTS ACTION
1 PURPOSE: VERIFY IF MALFUNCTION RELATED TO FUEL SYSTEM PIPES (LOW PRESSURE SIDE) AFFECTS DIAGNOSTIC RESULTS 
Yes Replace the fuel pump unit, then go to Step 3.
(See FUEL PUMP UNIT REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
No Inspect the fuel system pipes (low to high pressure sides) for fuel leakage and restriction.
  • If there is any malfunction:
    • Repair or replace the malfunctioning part according to the inspection results, then go to Step 3.
  • If there is no malfunction:
    • Go to the next step.
2 PURPOSE: DETERMINE INTEGRITY OF FUEL PRESSURE SENSOR 
Yes Replace the fuel distributor, then go to the next step.
(See FUEL INJECTOR REMOVAL/INSTALLATION [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
No Go to the next step.
3 PURPOSE: VERIFICATION OF VEHICLE REPAIR COMPLETION 
Yes Repeat the inspection from Step 1.

Go to the next step.
No Go to the next step.
4 PURPOSE: VERIFY IF THERE IS ANY OTHER MALFUNCTION 
  • Is any other DTC or pending code stored?
Yes Go to the applicable DTC inspection.
(See DTC TABLE [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
No DTC troubleshooting completed.