Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2014 >> 3 SV, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic - Engine Controls (1 Of 6) >> DTC B10A2 00: A Collision Signal From The SAS Control Module Is Received >> Details On DTCs

Details On DTCs

DETAILS ON DTCS

DESCRIPTION  Vehicle collision 
DETECTION CONDITION  Determination conditions
  • A collision signal from the SAS control module is received. 
Preconditions
  • Not applicable
Drive cycle
  • 1
Self test type
  • CMDTC self test
Sensor used
  • PCM
FAIL-SAFE FUNCTION 
  • Stops fuel injection control
  • Stops fuel pump control
  • Stops ignition control
  • Stops engine coolant fan control
VEHICLE STATUS WHEN DTCs ARE OUTPUT 
  • Stops fuel pump operation when ignition is switched ON
  • Delays starter operation during cranking for maximum 1.2 s  .
POSSIBLE CAUSE 
  • Vehicle is involved in collision (collision signal from SAS control module is received)
  • SAS control module malfunction
  • PCM malfunction
scientia non olet · About Mike's Workshop Manuals