Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2013 >> 3 Mazdaspeed, 2.3L Eng VIN 3 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System On-Board Diagnostic (MZR 2.3 DISI Turbo) - Introduction, After Repair Procedure, DTC Table >> On-Board Diagnostic Test >> DTC Reading Procedure

DTC Reading Procedure

  1. Connect the M-MDS (IDS) to the DLC-2.
    Fig 1: Identifying DLC-2 Location
    G08156153Courtesy of MAZDA MOTORS CORP.
  2. After the vehicle is identified, select the following items from the initialization screen of the IDS.
    1. Select "Self Test".
    2. Select "Modules".
    3. Select "PCM".
  3. Then, select the "Retrieve CMDTCs" and perform procedures according to directions on the IDS screen.
  4. Verify the DTC according to the directions on the IDS screen.
    • If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
  5. After completion of repairs, clear all DTCs stored in the PCM, while referring to "AFTER REPAIR PROCEDURE".
scientia non olet · About Mike's Workshop Manuals