Neutral Switch Removal/Installation
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5] ).
- Drain the transaxle oil. (See TRANSAXLE OIL REPLACEMENT ).
- Disconnect the neutral switch connector.
- Remove the neutral switch.
- Install the neutral switch (with a new gasket) to the transaxle case.
Tightening torque
20-29 N.m {2.1-2.9 kgf.m, 15-21 ft.lbf}
- Connect the neutral switch connector.
- Add the specified amount of specified transaxle oil. (See TRANSAXLE OIL REPLACEMENT ).
- Connect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 1.5] ).