Evaporative system test procedure

Verify that all PIDs are within the following specifications.
NOTE:
- To successfully perform this procedure, all PIDs must be within the specifications before proceeding to the next step.
Select the following items from the initialization screen of the M-MDS.
1. Select "Powertrain".
2. Select "Fuel".
3. Select "EVAP Test".
  - Verify that ECT1 and IAT are within specifications at the confirmation screen. To successfully perform this procedure, ECT1 and IAT must be within the spec before proceeding to the next step.
  - Fuel Level must be maintained within 15%-85% . PCM will cancel the EVAP Test If the Fuel Level is lower than 15% or higher than 85% .
    
    Fig 1: PID Range Specification
Verify the test results described on the M-MDS and folio