Throttle position (TP) sweep inspection

Connect the M-MDS to the DLC-2.
Turn the ignition switch to the ON position.
Verify that none of the following DTC are displayed: (See ON-BOARD DIAGNOSTIC TEST article.)
- P0122:00, P0123:00, P0222:00, P0223:00, P2101:00, P2107:00, P2112:00, P2122:00, P2123:00, P2127:00, P2128:00, P2135:00
  - If any one DTC is displayed, perform DTC inspection. (See DTC TABLE article.)
Access TP1 TP2 PID. (See ON-BOARD DIAGNOSTIC TEST article.)
Verify that the PID reading is within the CTP value. (See PCM INSPECTION article.)
- If the PID reading is out of range, perform the following:
  - Remove the air duct from the throttle valve body.
  - Verify that the throttle valve opens when the accelerator pedal is depressed.
    - If the throttle valve opens, inspect the throttle position sensor and related wiring harness. (See THROTTLE POSITION (TP) SENSOR INSPECTION article.)
    - If the throttle valve does not open, inspect the throttle actuator control motor and related wiring harness.
Gradually depress the throttle pedal and verify that the PID reading increases accordingly.
- If the PID reading drops momentarily, inspect the following:
  - Throttle position sensor (See THROTTLE POSITION (TP) SENSOR INSPECTION article.)
Fully depress the throttle pedal and verify that the PID reading is within WOT value. (See PCM INSPECTION article.)
- If the PID reading is out of range, perform the followings:
  - Remove the air duct from throttle valve body.
  - Verify that the throttle valve opens when throttle pedal is depressed.
    - If the throttle valve opens, inspect the throttle position sensor and related wiring harness. (See THROTTLE POSITION (TP) SENSOR INSPECTION article.)
    - If the throttle valve does not open, inspect the throttle actuator control motor and related wiring harness.