Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2012 >> 6 s Touring Plus >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> With M-MDS Scan Tool

With M-MDS Scan Tool

NOTE: Use the LDS (laptop PC). The PDS (pocket PC) does not support wheel unit ID registration and monitoring wheel unit ID.
NOTE: When using the M-MDS scan tool to perform the ID registration, record the initial ID data and verify the data has changed after driving for 10 minutes or more.
  1. Turn ignition switch to ON position, then turn it back to LOCK position.
  2. Connect M-MDS scan tool and identify the vehicle.
  3. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
  4. Select "BODY", then "TPMS FUNCTION", then "WHEEL UNIT ID REGISTRATION".
  5. Select "WU_ID REGISTRATION".
    NOTE: Before driving, record the initial ID data stored in the scan tool, to verify the data has changed.
  6. Leave the vehicle with the engine off, and wait for 15 minutes or more.
  7. Verify the TPMS warning light turns ON and OFF in 0.5 second repeat cycles.
  8. After 15 minutes or more, drive vehicle at a speed of at least 16 mph (25 km/h) for 10 minutes or more. Tire pressure sensor ID registration is complete when the TPMS warning light turns OFF.
scientia non olet · About Mike's Workshop Manuals