Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2012 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System [MZR 2.5]) >> Knock Sensor (KS) Removal/Installation

Knock Sensor (KS) Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  2. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION .)
  3. Remove the intake manifold. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  4. Disconnect the KS connector.
  5. Remove the KS.
    Fig 1: Lnock Sensor And Bolt With Torque Specification
    G08140798
  6. Install in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals