Thrust Washer Assembly Note
- Align the tabs of the friction damper and thrust washer and assemble.
- Measure the dimension A as shown in the figure.
- If not within the specification, select a suitable thrust washer from the table below so that the dimension is within the specification.
Reverse idler gear component dimension
57.225-57.275 mm {2.2529-2.2549 in}
REVERSE THRUST WASHER THICKNESS (MM {IN})2.04 {0.0803} 2.24 {0.088} 2.09 {0.082} 2.29 {0.090} 2.14 {0.084} 2.34 {0.092} 2.19 {0.086} 2.39 {0.094}