Key Interlock Solenoid Inspection

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Do not allow foreign material or water to penetrate the connector. Otherwise, it could cause poor contact and corrosion.

Disconnect the key interlock solenoid connector.
1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
2. Disconnect the negative battery cable.
3. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION .)
4. Disconnect the key interlock solenoid connector.
  
  Fig 1: Identifying Key Interlock Solenoid Connector
Measure the resistance between the key interlock solenoid terminals A and B.

Fig 2: Identifying Key Interlock Solenoid Connector Terminals
- If there is any malfunction, replace the steering lock. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
  Key Interlock Solenoid Resistance
- 32.4-39.6 ohm