Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2012 >> 5 Sport, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Automatic Transaxle [Shift Mechanism]) >> Automatic Transaxle Shift Mechanism Removal/Installation >> Selector Cable Removal/Installation

Selector Cable Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  2. Disconnect the negative battery cable.
  3. Remove the battery. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  4. Remove the battery tray. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
  5. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [MZR 2.5] .)
  6. Remove the aerodynamic under cover. (See AERODYNAMIC UNDER COVER REMOVAL/INSTALLATION .)
  7. Remove the insulator (No.5) installation nuts and set the insulator (No.5) aside. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [MZR 2.5] .)
  8. Remove the center console box. (See CENTER CONSOLE BOX REMOVAL/INSTALLATION .)
  9. Remove the console panel. (See CONSOLE PANEL REMOVAL/INSTALLATION .)
  10. Remove the center console. (See CENTER CONSOLE REMOVAL/INSTALLATION .)
  11. Remove the selector lever knob. (See SELECTOR LEVER COMPONENT REMOVAL/INSTALLATION .)
  12. Remove the shift panel. (See SHIFT PANEL REMOVAL/INSTALLATION .)
  13. Remove the side wall. (See SIDE WALL REMOVAL/INSTALLATION .)
  14. Remove the front console. (See FRONT CONSOLE REMOVAL/INSTALLATION .)
  15. Disconnect the drain hose wire from the A/C unit. (See A/C UNIT REMOVAL/INSTALLATION .)
  16. Remove in the order shown in the figure.
  17. Install in the reverse order of removal.
  18. Inspect the selector lever. (See SELECTOR LEVER INSPECTION .)
    Fig 1: Selector Lever Related Replacement Components With Torque Specifications
    G08150778
scientia non olet · About Mike's Workshop Manuals