Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2012 >> 2 Touring, 1.5L Eng VIN Z, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transaxle {Shift Mechanism}) >> Automatic Transaxle Shift Mechanism Removal/Installation >> Selector Lever component Removal/Installation

Selector Lever component Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the selector lever component connector.
    1. Disconnect the negative battery cable.
    2. Remove the side wall. (See SIDE WALL REMOVAL/INSTALLATION .)
    3. Remove the front console component. (See FRONT CONSOLE COMPONENT REMOVAL/INSTALLATION .)
    4. Disconnect the selector lever component connector.
      Fig 1: Identifying Selector Lever Component Connector
      G08095932
  2. Remove the selector lever component.
    1. Disconnect the interlock cable from the selector lever component.
      Fig 2: Interlock Cable And Selector Lever
      G08095933
    2. Disconnect the selector cable from the selector lever component.
      Fig 3: Selector Cable And Selector Lever With Torque Specifications
      G08095934
    3. Remove the selector lever component.
      Fig 4: Selector Lever Components With Torque Specifications
      G08095935
  3. Install in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals