Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> RX-8 R3, 1.3 2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 593 (Lighting System) >> Panel Light Control Switch Inspection >> Notes

Panel Light Control Switch Inspection: Notes

WARNING: This page is about a different car, the 2010 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the panel light control switch connector.
  2. Connect the negative battery cable.
  3. Measure the voltage at each terminal.
    • If the voltage is not as specified in the Terminal Voltage Table (Reference), inspect the parts under "Inspection item(s)".
  4. Disconnect the panel light control switch connector.
    • If there is any malfunction, inspect the parts under "Inspection item(s)".
    • If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the panel light control switch.
scientia non olet · About Mike's Workshop Manuals