Visual Inspection

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION .)
Disconnect the MAF/IAT sensor connector.
Remove the MAF/IAT sensor. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
Visually inspect the MAF/IAT sensor for the following:
- Damage, cracks, soiling
- Rusted sensor terminal
- Bent sensor terminal
- If there is any malfunction, repair or replace the MAF/IAT sensor. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)