Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System [MZR 2.5]) >> Manifold Absolute Pressure (Map) Sensor Inspection

Manifold Absolute Pressure (Map) Sensor Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Connect the M-MDS to the DLC-2.
  2. Switch the ignition to ON.
  3. Verify that the MAP sensor output voltage (PID: MAP) within the specification. (See ON-BOARD DIAGNOSTIC TEST .) (See PCM INSPECTION .)
Fig 1: DLC-2
G07620726Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals