Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Manual Transaxle (Service, Removal & Installation G66M-R)) >> Manual Transaxle Removal/Installation >> Manual Transaxle Installation Note

Manual Transaxle Installation Note

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • Install the transaxle carefully, holding it steady. If the transaxle falls it could be damaged or cause injury.
  1. Set the transaxle on a jack and lift into place.
  2. Install the transaxle mounting bolts.
  3. Adjust the SST  (49 C017 5A0) so that the engine is located at the specified position.
    Fig 1: Setting Transaxle On Jack
    G07625813Courtesy of MAZDA MOTORS CORP.
  4. install the brake hose to the bracket and tighten the bolt shown in the illustration.
Fig 2: Brake Hose Bolt With Torque Specification
G07625814Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals