Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (On-Board Diagnostic [Engine Control System MZR 2.5]) >> DTC P2135:00 >> Notes

DTC P2135:00: Notes

WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION REFERENCE CHART

DTC P2135:00 TP sensor No. 1/No. 2 voltage correlation problem
DETECTION CONDITION 
  • The PCM compares the input voltage from TP sensor No. 1 with the input voltage from TP sensor No. 2 when the engine is running. If the difference is more than the specification, the PCM determines that there is a TP sensor No. 1/No. 2 voltage correlation problem.

Diagnostic support note 

  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Throttle body connector or terminal malfunction
  • TP sensor No. 1 malfunction
  • TP sensor No. 2 malfunction
  • PCM connector or terminal malfunction
  • PCM malfunction
scientia non olet · About Mike's Workshop Manuals