Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (On-Board Diagnostic [Engine Control System MZR 2.5]) >> DTC P061B:00 >> Notes

DTC P061B:00: Notes

WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION REFERENCE CHART

DTC P061B:00 Internal control module torque calculation performance problem
DETECTION CONDITION 
  • Indicates that a calculation error occurred in the PCM.

Diagnostic support note 

  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • The DTC is stored in PCM memory.
POSSIBLE CAUSE 
NOTE:
  • This DTC is an informational DTC and may be set in combination with a number of other DTCs which are causing the FMEM. Diagnose other DTCs first.
  • PCM connector or terminal malfunction
  • PCM malfunction
scientia non olet · About Mike's Workshop Manuals