Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 6 s Touring Plus >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (On-Board Diagnostic [Engine Control System MZR 2.5]) >> DTC P0602:00 >> Notes

DTC P0602:00: Notes

WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION REFERENCE CHART

DTC P0602:00 PCM programming error
DETECTION CONDITION 
  • No configuration data in the PCM.
NOTE:
  • If the "PCM CONFIGURATION" is successful, the PCM stores DTC P0602:00 and illuminates the MIL (system is normal). Clear the DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION".
  • The MIL goes out after three drive cycles with no failure (DTCs remain in PCM).
Diagnostic support note 
  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Configuration has not been completed
  • PCM malfunction
scientia non olet · About Mike's Workshop Manuals