Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 3 i SV, 2.0 F >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Power Systems >> Starter Cut Relay Inspection [MTX] >> Advanced Keyless Entry And Push Button Start System Only

Advanced Keyless Entry And Push Button Start System Only

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION ).
    2. Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
    3. Side wall (See SIDE WALL REMOVAL/INSTALLATION ).
    4. Console (See CONSOLE REMOVAL/INSTALLATION ).
  3. Set the bonnet release lever out of the way. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION ).
  4. Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION ).
  5. Remove the starter cut relay with the connector connected. (See STARTER CUT RELAY REMOVAL/INSTALLATION [MTX] ).
  6. Connect the negative battery cable.
  7. Measure the voltage at each terminal is as indicated in the terminal voltage tables.
    • If the voltage or continuity is not as specified in the terminal voltage table, inspect the parts under "Inspection item (s)".
      • If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the starter cut relay.
scientia non olet · About Mike's Workshop Manuals