Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System [LF, L5]) >> Manifold Absolute Pressure (Map) Sensor Removal/Installation

Manifold Absolute Pressure (Map) Sensor Removal/Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] ).
  2. Disconnect the negative battery cable.
  3. Remove the plug hole plate. (See PLUG HOLE PLATE REMOVAL/INSTALLATION ).
  4. Disconnect the MAP sensor connector.
  5. Remove the MAP sensor.
  6. Install in the reverse order of removal.
    Fig 1: MAP Sensor And Intake Manifold With Torque Specifications
    G07868523Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals