Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 629 (Engine Control System) >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Removal/Installation >> Notes

Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Removal/Installation: Notes

WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [13B-MSP] )
  2. Disconnect the negative battery cable.
  3. Remove the MAF/IAT sensor connector.
  4. Remove in the order indicated in the table.
    5. Fig 1: MAF/IAT Sensor Screws With Torque Specifications
    G05981134Courtesy of MAZDA MOTORS CORP.
  5. Install in the reverse order of removal.
scientia non olet · About Mike's Workshop Manuals