Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 571 (On-Board Diagnostic [Immobilizer System (Advanced Keyless Entry And Push Button Start System)]) >> Clearing DTC [Immobilizer System (Advanced Keyless Entry And Push Button Start System)]

Clearing DTC [Immobilizer System (Advanced Keyless Entry And Push Button Start System)]

WARNING: This page is about a different car, the 2010 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the M-MDS to the DLC-2.
  2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Self Test".
      2. Select "Modules".
      3. Select "RKE".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "RKE".
      3. Select "Self Test".
  3. Verify the DTC according to the directions on the screen.
  4. Press the clear button on the DTC screen to clear the DTC.
  5. Switch the ignition to off.
  6. Switch the ignition to ON and wait for 5 s or more. 
  7. Perform DTC inspection. (See DTC INSPECTION [IMMOBILIZER SYSTEM (ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM)] .)
  8. Verify that no DTCs are displayed.
    Fig 1: Identifying DLC-2
    G06734053Courtesy of MAZDA MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals