Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Mazda >> 2011 >> 3 Mazdaspeed, 2.3 4 >> Repair and Diagnosis >> Engine Performance >> System >> Symptom Troubleshooting [Engine Mechanical L3 With TC] >> Engine Control System Operation Inspection >> Drive-by-wire Control System Inspection >> Evaporative system test procedure

Evaporative system test procedure

  1. Verify that all PIDs are within the following specifications.
    NOTE:
    • To successfully perform this procedure, all PIDs must be within the specifications before proceeding to the next step.
  2. Select the following items from the initialization screen of the M-MDS.
    1. Select "Powertrain".
    2. Select "Fuel".
    3. Select "EVAP Test".
      • Verify that ECT and IAT are within specifications at the confirmation screen. To successfully perform this procedure, ECT and IAT must be within the spec before proceeding to the next step.
      • Fuel Level must be maintained within 15%-85%  . PCM will cancel the EVAP Test If the Fuel Level is lower than 15%  or higher than 85%  .
        Fig 1: Display PID Specfications
        G05507602Courtesy of MAZDA MOTORS CORP.
  3. Verify the test results described on the M-MDS and follow the instructions.
scientia non olet · About Mike's Workshop Manuals