Brake override system operation inspection

NOTE:

If the brake override system operates normally after performing the following inspections, the PCM stores DTC P2299:00.

Start the engine and run it is idling.
Verify that the engine speed becomes less than 1, 100 rpm under the following conditions.
- Neutral
- Engine speed of 1, 150 rpm or more other than idle
- Brake pedal depressed
  - If the engine speed becomes less than 1, 100 rpm , clear the PCM DTC using the M-MDS. (System operation is normal).
  - If the engine speed does not become less than 1, 100 rpm , inspect for the following parts, then repair or replace the malfunctioning part:
    - APP sensor (See ACCELERATOR PEDAL POSITION (APP) SENSOR INSPECTION ).
    - Neutral switch (See NEUTRAL SWITCH INSPECTION ).
    - Clutch switch (See CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTION ).
    - Brake switch No. 1 (See BRAKE SWITCH INSPECTION ).
    - Brake switch No. 2 (See BRAKE SWITCH INSPECTION ).